| Last Modified: 11-29-2007 | 1.6 A | |
| Service Category: Engine/Hybrid System | Section: Engine Mechanical | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000002OP800GX |
| Title: 3UR-FE ENGINE MECHANICAL: CYLINDER HEAD: DISASSEMBLY (2008 Sequoia) | ||
DISASSEMBLY
1. REMOVE INTAKE VALVE
|
(a) Using SST and wooden blocks, compress the compression spring and remove the valve retainer locks. SST: 09202-70020 |
(b) Remove the retainer, compression spring and valve.
HINT:
Arrange the removed parts in the correct order.
2. REMOVE EXHAUST VALVE
|
(a) Using SST and wooden blocks, compress the compression spring and remove the valve retainer locks. SST: 09202-70020 |
(b) Remove the retainer, compression spring and valve.
HINT:
Arrange the removed parts in the correct order.
3. REMOVE VALVE STEM OIL SEAL
|
(a) Using needle-nose pliers, remove the oil seals. |
4. REMOVE VALVE SPRING SEAT
|
(a) Using compressed air and a magnetic finger, remove the valve spring seat by blowing air onto it. |
5. REMOVE NO. 1 STRAIGHT SCREW PLUG
NOTICE:
If water leaks from the No. 1 screw plug or the plug is corroded, replace it.
|
(a) Using a 10 mm hexagon wrench, remove the 6 screw plugs and 6 gaskets. |
6. REMOVE NO. 2 STRAIGHT SCREW PLUG
|
(a) Using a 14 mm hexagon wrench, remove the 2 screw plugs and 2 gaskets. NOTICE:
If water leaks from the No. 2 screw plug or the plug is corroded, replace it. |
7. REMOVE STUD BOLT
NOTICE:
If the stud bolt is deformed or its threads are damaged, replace it.
|
|